Magic Chef Gas Oven F7

Appliance411 Sponsored in part by


Forum Archive

Magic Chef Gas Oven

Scott -- Sunday, 22 December 2002, at 8:28 p.m.

Have error on clock display "F7" and do not have an owners manual

Re: Magic Chef Gas Oven *LINK* *PIC*

Dan O. -- Sunday, 22 December 2002, at 9:59 p.m.

: Have error on clock display "F7" and
: do not have an owners manual

F7 on Magic Chef ranges usually indicates a defect in the keypad for the range control and usually requires the keypad to be replaced to correct such an occurrence.

Often those keypads are only listed as part of the whole "control panel" but some popular models may be able to utilize just the keypad available separately as listed at our page linked below.

JFYI

Dan O.
Appliance411
The Appliance Information Site
=D~~~~~~


Repair Parts : Showcase : Magic Chef


Re: Magic Chef Gas Oven

Jim -- Sunday, 22 December 2002, at 10:02 p.m.

: Have error on clock display "F7" and
: do not have an owners manual

F-7 shuts down all cooking modes and sounds an alarm. This is due to a shorted key pad. There is always a slight chance that the wiring ribbon between the keypad and electronic control may just be loose but rarely the case. Replacement of the keypad assembly is usually required.

Try cutting power to the oven for a minute and restore. This will reset the fault and at least allow operation during Christmas hopefully. Good luck.

Re: Magic Chef Gas Oven

Scott -- Monday, 23 December 2002, at 11:42 p.m.

: F-7 shuts down all cooking modes and sounds an
: alarm. This is due to a shorted key pad.
: Magic Chefs are notorious for this problem
: -especially the models with the tri-angle
: shaped keys. There is always a slight chance
: that the wiring ribbon may be loose but
: rarely the case. Replacement of the keypad
: assembly is required. Try cutting power to
: the oven for a minute and restore. This will
: reset the fault and at least allow operation
: during Christmas. Good luck.

Thank you for the responce. It happened twice and has not happened again. Will keep our fingers crossed! Thanks again. Scott


Appliance411 Sponsored in part by



Return to the Appliance411 Home Page
Appliance411 Home

Repair Parts | Archive Search | Q&A Forum | Refer this Page

All forum content Copyright © Appliance411 & the respective author.
All rights reserved. 1997-2025
Please support Appliance411
Click to find out how