KENMORE MICROWAVE OVEN TRAY

KENMORE MICROWAVE OVEN TRAY

GREG -- Sunday, 17 March 2002, at 1:20 p.m.

I BROKE MY ROTATING DISH AND WOULD LIKE TO GET A REPLACEMEMNT, [42.00 TOO MUCH]. I WOULD LIKE TO KNOW THE MANUFACTURE CODE 565.8954790. THIS SITE HELPED A LOT BUT DID NOT KNOW THE CODE.

Re: KENMORE MICROWAVE OVEN *LINK* *PIC*

Dan O. -- Sunday, 17 March 2002, at 1:58 p.m.

: I BROKE MY ROTATING DISH AND WOULD LIKE TO GET
: A REPLACEMEMNT, [42.00 TOO MUCH]. I WOULD
: LIKE TO KNOW THE MANUFACTURE CODE
: 565.8954790.

I'm afraid I have no idea whom made that unit for Sears but replacement microwave oven trays are expensive and doubt you find it much cheaper by going right to the manufacturer as illustrated below. Sorry.

Dan O.

PS. It is considered bad netiquette (net etiquette) to type in ALL CAPITAL LETTERS when communicating via electronic mediums (email, forums, etc.) and may also make messages difficult to read. Please refrain from it when posting here. Thanks.

Kenmore 565.8954790 Tray

Re: KENMORE MICROWAVE OVEN

Dan O. -- Friday, 22 March 2002, at 4:33 p.m.

: I WOULD LIKE TO KNOW THE MANUFACTURE CODE
: 565.8954790

Apparently that model Kenmore microwave was made by Sanyo.

Dan O.

Re: KENMORE MICROWAVE OVEN

GREG -- Friday, 22 March 2002, at 8:44 p.m.

: Apparently that model Kenmore microwave was
: made by Sanyo.

: Dan O.

Thanks for the help and time spent looking for my part. Sorry I did not mean to shout.

Re: KENMORE MICROWAVE OVEN

Dan O. -- Friday, 22 March 2002, at 10:40 p.m.

: Thanks for the help and time spent looking for my part.

No problem.

Like I said, the trays for microwaves are quite expensive (especially compared to what they sell the whole units for). You may be able to find a used one if you check local microwave oven service depots but there are so many different sizes and designs of turntables in use, it is very difficult to find the correct replacement.

If you intend to keep the microwave, you may have to bite the bullet and just purchase one.

: Sorry I did not mean to shout.

That's Ok too. Better you hear it from me than some of the people you're likely to meet on the Internet. They can be quite rude about it.

Dan O.
Appliance411
The Appliance Information Site
=D~~~~~~